EasyManuals Logo

Pepwave Peplink MAX Series User Manual

Pepwave Peplink MAX Series
404 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #302 background imageLoading...
Page #302 background image
Scenario 4: SIM Injector in a remote location
Setup topology
Requirements for installing a SIM Injector in a remote location:
Cellular router communicates with the SIM Injector via UDP port 50000. Therefore
this port must be reachable via public IP over the Internet.
The one way latency between the cellular router and the SIM Injector should be up to
250 ms. A higher latency may lead to stability issues.
The cellular router must have Internet connection to connect to the SIM Injector. It
can be another Internet connection via Ethernet or Fiber if possible, or a secondary
cellular interface with a local SIM (Ignite SIM).
Due to its high latency, it is not recommended to use satellite WAN for connecting to
a SIM Injector in remote locations.
SIM Injector configuration is the same as in Scenario 1.
Cellular Router configuration
Step 1. Enable the SIM Injector communication protocol.
1a. For a Balance cellular router, go to the Network (Top tab).
1b. For a MAX cellular router, go to the Advanced (Top tab).
2. Under Misc. settings (Left-side tab), find Remote SIM Management.
3. In Remote SIM Management, click on the edit icon next to Remote SIM is Disabled.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pepwave Peplink MAX Series and is the answer not in the manual?

Pepwave Peplink MAX Series Specifications

General IconGeneral
BrandPepwave
ModelPeplink MAX Series
CategoryNetwork Router
LanguageEnglish

Related product manuals