Layer 2 PepVPN Bridging
PepVPN Profiles
to Bridge
The remote network of the selected PepVPN profiles will be bridged with this local
LAN, creating a Layer 2 PepVPN, they will be connected and operate like a single
LAN, and any broadcast or multicast packets will be sent over the VPN.
Isolation
Enable this option if you want to block network traffic between the remote networks,
this will not affect the connectivity between them and this local LAN.
Protocol
Click the box will enable STP for this layer 2 profile bridge.
Override IP
Address when
bridge
connected
Select "Do not override" if the LAN IP address and local DHCP server should remain
unchanged after the Layer 2 PepVPN is up.
If you choose to overrid
e IP address when the VPN is connected, the device will not
act as a router, and most Layer 3 routing functions will cease to work.
DHCP Option 82
Click on the question Mark if you want to enable DHCP Option 82.
This allows the device to inject Option 82
with Router Name information before
forwarding the DHCP Request packet to a PepVPN peer, such that the DHCP Server
can identify where the request originates from.
To Next Page
Loading...
Need help?
General
