38 . Spectrum Two N User's Guide
7. Ensure that the POWER LED on the front of the wireless router is lit green (Figure 19).
The POWER LED will flash while the router initializes.
Figure 19 POWER LED on the wireless router
8. Wait for the POWER LED on the router to stop flashing and ensure that the WIRELESS
LED is lit (Figure 20).
Figure 20 Wireless router LEDs indicate ready for use
9. Switch on your PC and then connect to the PerkinElmer FT-IR Wireless network.
You will need to enter the network security key provided on the side of your router.
Figure 21 Connecting to the PerkinElmer FT-IR Wireless network (example only)
The exact procedure for connecting your PC to the wireless network will depend on your
wireless hardware and on the PC operating system.
flashing