1-12
Patchwork program
With this function, you can specify a particular seam length for joining together several pieces of fabric of equal length
and save it permanently when exiting the menu (e.g. for patchwork).
Dialogue window: Open already saved programs or create a new one. Touch “ON“ to activate the function.
Sew the desired length, in order to determine a new seam length. The start of the seam is automatically tied off.
If you press the reverse button when you reach the end of the seam, it will be tied off. All subsequent seams are now
automatically sewn in your specified length.
With this icon, you increase the programmed length of the seam.
With this icon, you reduce the programmed length of the seam.
With this icon, you open a window for opening, saving, deleting and closing a program.
Twin needle
With this function, you reduce the width of your stitch in order to use a twin needle.
This function must be switched off again when you remove the needle from the machine.
It remains active even after the stitch has been changed, including after the machine has been switched off and back
on again. Touch the icon again, then “ON“ to turn off the function.
Dialogue window: Open already saved programs or create a new one. Touch “ON“ to activate the function. Touch
“ON“ again to turn off the function.
Youcanenterthespacingwidthofthetwinneedleyouareusingwiththe+/-icons.Thewidthofthestitchisnow
reduced in such a way that the selected dimension is not exceeded. The stitch is depicted by a twin needle on the
screen.
Four sewing directions program
With this function, you can program the length and width of a rectangle. The program can be saved permanently in
the machine. Use this function for sewing on patches without having to turn the fabric.
Touch this function before starting to sew, to program and permanently save a ”four sewing directions program”.
Touch this function to decide where to end an already programmed side seam. The machine completes the current
stitch and stops.
This icon is active when the function is opened. The arrow icons decides the sewing direction. The machine sews in
the direction of the selected arrow.
When the desired seam length is obtained, press the reverse button to change sewing direction. The machine sews in
the selected direction until the reverse button is pressed again. Repeat for all sides in the rectangle.
Also the direction arrows can be used to change the sewing direction. Touch the direction arrow following the current-
ly selected, and the machine changes direction and sews in the latest selected.
Touch this icon to call up further functions for processing or modifying the program.
Touch it a further time to close the window.
With this icon you open a window for opening, saving, deleting and closing a program.
This icon allows you to open a window for correcting the balance of the rectangle. Use the sewn sample for reference
when adjusting the length of the individual sides.
Usethe+/-iconstoadjusttherectangleonthescreenuntilitlookslikeyoursewnsample.Therectanglewillbe
adjusted automatically the next time you sew.
+
–
To Next Page
Loading...
Need help?
General
