2-52. Machine Assistant
Winding a bobbin through the needle
It is possible to wind bobbins even when the machine is fully threa-
ded (see page 2-8 for threading instructions).
Raise the presser foot. Pull the needle thread underneath the
presser foot and upward through the right-hand threader slot.
Place the thread from left to right through the take-up lever F.
Note: The take-up lever must be at its highest position.
Guide the thread to the right. Wind the start of the thread around
the bobbin several times in a clockwise direction. Start bobbin
winding by pushing the bobbin lever to the right. As soon as the
bobbin is full, the winding action will be stopped automatically. Cut
the thread and remove the bobbin from the winder.
F
To Next Page
Loading...
Need help?
General
