3 Transportation and Storage
3.1 Receipt of the product
Condition of the delivery
●
Check that the product has not been damaged during transport.
●
If the product is damaged, take the necessary measures with the carrier and notify the
manufacturer.
►
Check the packaging reversal indicator (if present).
►
Keep the product in its original packaging so it stays as clean as it was when dispatched by us.
Only unpack the product once it has arrived at the location where it will be used.
►
Keep the blanking plates in place on the inlet, exhaust and purge ports while the product is not
connected to the pumping line.
Keep the packaging (recyclable materials) in case the product needs to be transported or
stored.
3.2 Handling
WARNING
Risk of crushing when the electronic drive unit installed on a magnetically levitated pump is
suspended
Due to the weight of the magnetically levitated pump and electronic drive unit assembly, there is a
risk of crushing during handling. Under no circumstances shall the manufacturer be liable if the fol-
lowing instructions are not followed:
►
Only qualified staff trained in handling heavy objects are authorized to handle the product.
–
Use appropriate lifting rings screwed into holes provided for this purpose (see pump operat-
ing instructions).
►
Wear safety shoes with a steel toe in accordance with directive EN 347.
WARNING
Risk of crushing related to product tilting
Although the product meets EEC safety regulations, there is a risk of tilting during product handling,
installation and operation.
►
Do not place the product on an inclined plane.
►
Do not push the product sideways.
►
Always secure the pump until it has been integrated into the equipment using the devices sup-
plied.
Handling the OBC installed on a magnetically levitated pump
The OBC electronic drive unit is an integral part of the magnetically levitated pump. It is usually
installed on the pump on delivery and the ‘pump and electronic drive unit’ assembly cannot be
handled without it.
When handling the pump and electronic drive unit assembly, a lifting device that is appropriate for
the weight of the product must be used. The weight and center of gravity vary depending on the
pump model.
►
Refer to the magnetically levitated pump operating instructions.
Transportation and Storage
13/60
To Next Page
Loading...
Need help?
General
