8.2.3 SETUP menu
Selection Choice Description
Initial setting
1)
ACCESS CODE 0 to 65535 0
REMOTE CONTROL KEYBOARD
REMOTE HARD
SERIAL LINK
LONWORKS
DEVICENET
PROFIBUS
ETHERCAT
Choose the interface control mode. According to ordering
guide.
STAND-BY SPEED
from 15000 min
-1
to pump
nominal speed
Activate pump Stand-by speed (select-
ed speed) between minimum speed and
nominal speed (= speed set at factory).
15000
BUZZER ON
OFF
Activate the acoustic signal in case of
default. To stop the signal, press OFF.
OFF
THERMOSTAT ON = 30 to 75 °C
OFF
Activate the pump temperature set-
point.
OFF (M version)
ON = 30 °C (MT ver-
sion)
RELAY AT SPEED -3 to 50 % of the nominal
speed
Modify the speed contact setpoint. - 3 %
FIELDBUS PRO-
FILE
2)
0
1
0 = compatible with OBCV4, OBCV5.
1 = compatible with OBCV3.
0
FIELDBUS AD-
DRESS
2)
RS-232 SPEED 9K6
19K2
38K4
57K6
Choose the RS-232 serial link transmis-
sion speed.
9K6
RS-232 ECHO ON
OFF
Activate all received characters to be
echoed over the RS-232 serial link.
OFF
RS SEPARATOR 0 to 255 Enter the separator character in ASCII:
e.g. “044” for “,”.
44
RS ADDRESS 0 to 255 Number given to the pump in the serial
link.
0
BEARING LIVE
Warning limit
0 to 99 % Modify the landing bearing warning
threshold.
20
NEW CODING 0 to 65535 Modify the access code. 0
1) For client's specification product, inital settings could be different (see chapter “Product concerned”).
2) Refer to the operating manual of the fieldbus interface that controls the pump.
8.2.4 Menu SER NUM
Selection Display Initial settings
HHR Affichage du numéro de série du boîtier de commande déportable.
Display the HHR serial number.
XXXXXXXXXX
FRONT PANEL Part number : display the pump part number
Serial number : display the pump serial number (available depending on the
type of pump).
YYYYYYYYYY
Interfaces for control
33/60
To Next Page
Loading...
Need help?
General
