Index Phason
98 2009-06-15
R (continued)
restoring settings ...................................... 69–70
ribbon cable.................................................... 13
routing data wires ........................................... 12
S
saving settings.......................................... 69–70
sealing ........................................... See moisture
security ............................................ 2, See PINs
selecting temperature units ............................ 30
servicing the PEC Plus ............................. 67–68
settings .................................. See programming
settings saver........................... See PEC+ Saver
single-stage cooling/heating
configuring ................................ 37–38, 54–57
connecting ................................................. 17
programming ............................ 37–38, 54–57
specific probe temperatures..................... 61–62
stage test mode........................................ 63–64
status LEDs....................................................... 6
surge suppression...................................... 9–10
T
target temperatures ........ See group set point or
growth curve
temperature
averaging ........................................ 22, 31–32
display................................................... 61–62
set points .......................... See programming
units ........................................................... 30
temperature probes.......................................... 4
configuring............................................ 31–32
connecting ............................................ 13, 22
extending ................................................... 23
temperature test mode.............................. 64–65
testing.................................................. 39, 63–66
three-phase power ......................................... 20
time........................................ See date and time
U - V
units................................ See temperature, units
updating firmware ..................................... 71–72
variable stages
configuring...................................... 33, 46–48
connecting ............................................ 13, 19
programming .................................. 33, 46–48
ratings ........................................................ 10
using as ON/OFF stages ........................... 47
version........................................... See firmware
voltage selection switch ................................. 13
To Next Page
Loading...
