PEC Plus user manual What you need to know before installing your PEC Plus
31040003 11
Precautions, guidelines, and warnings
Read Servicing and maintaining your PEC Plus on page 67.
The PEC Plus must be installed by a qualified electrician.
Before installing or servicing the PEC Plus, switch OFF the power at the source.
Install the PEC Plus and all equipment connected to it according to local electrical
codes.
Mount the control on a
sheltered, vertical surface,
with the electrical knockouts
facing down.
Use a screwdriver to tighten
the screws in the enclosure.
Do not use a drill or over
tighten the screws; this can
crack the enclosure and ruin
the watertight seal.
Use the electrical knockouts for bringing wires or cables
into or out of the enclosure. Use watertight strain reliefs
or conduit connectors at all cable-entry points.
Do not make additional holes in the enclosure; this can
damage the watertight seal or control components and
void the warranty.
To Next Page
Loading...
