10 Repair and Disassembly
206
All components of the front end assembly are now separated.
Reassembling the Front End Assembly
The procedure to reassemble the front end assembly is a reversal of the removal procedure. Ensure all
the cables are properly reconnected.
Exchanging the Bus Master Board
1 Remove the front end assembly -- see “Removing the Front End Assembly” on page 200.
2 Strip the front end assembly down to its component parts -- see “Disassembling the Front End
Assembly” on page 202.
3 Take a new bus master board and reassemble the front end assembly -- see “Reassembling the
Front End Assembly” on page 205.
Exchanging the Fetal Socket Connector Block
1 Remove the front end assembly -- see “Removing the Front End Assembly” on page 200.
2 Strip the front end assembly down as far as the end of step 5 under “Disassembling the Front End
Assembly” on page 202.
3 Take a new fetal socket connector block.
4 Reassemble the front end assembly -- see “Reassembling the Front End Assembly” on page 205.
To Next Page
Loading...
