Phoenix Contact FL MGUARD RS4000 User Manual

FL MGUARD RS4000 TX/TX-P
105656_en_05 PHOENIX CONTACT 135
6.10 Restart, recovery procedure, and flashing the firm-
ware
The reset button is used to set the device to one of the following states:
– Performing a restart
– Performing a recovery procedure
– Flashing the firmware/rescue procedure
Figure 6-6 Reset button
6.10.1 Performing a restart
Objective The device is restarted with the configured settings.
Action • Press the Reset button for around 1.5 seconds until the ERR LED lights up.
(Alternatively, disconnect the power supply and then connect it again.)
Reset button

Phoenix Contact FL MGUARD RS4000 Specifications

General

Brand	Phoenix Contact
Model	FL MGUARD RS4000
Category	Network Router
Language	English