TC MGUARD RS4000/RS2000 4G
92
PHOENIX CONTACT 105656_en_05
4.9 Restart, recovery procedure, and flashing the firm-
ware
The Reset button is used to set the device to one of the following states:
– Performing a restart
– Performing a recovery procedure
– Flashing the firmware/rescue procedure
Figure 4-9 Reset button
4.9.1 Performing a restart
Objective The device is restarted with the configured settings.
Action • Press the Reset button for around 1.5 seconds until the Err LED lights up.
(Alternatively, disconnect the power supply and then connect it again.)
To Next Page
Loading...
Need help?
General
