PianoDisc 228CFX - Table of Contents

To Next Page

To Previous Page

PianoDisc Installation Guide 5

. . . . .

TABLE OF CONTENTS

Introduction .................................................................................................... 3

FCC INFORMATION ..................................................................................... 4

Step 1: Disassemble the Piano ...................................................................... 8

Step 2: Measure the key groups .................................................................. 10

Step 2 Measure for the key groups (continued) .........................................................12

Step 3: Measure the keyframe cut ............................................................... 13

Step 4: Keyframe bedding ........................................................................... 14

Step 5: Cut the keyframe ............................................................................. 15

Step 6: Trace the keyframe .......................................................................... 16

Steps 6-11 – a convenient time saving tip ...................................................................16

Step 7: Transfer your measurements .......................................................... 16

Step 8: Determine location for the solenoid rail slot ..................................... 17

Step 9: Drill the keybed ................................................................................ 20

Step 10: Prepare to cut the slot ................................................................... 20

Step 11: Cutting the slot ............................................................................... 21

Step 12: Reinforce the keybed ..................................................................... 22

Step 13: Making, mounting, and marking rail cover ..................................... 23

Step 14: Leg alterations for placement of rail cover ..................................... 24

Step 15: Preparing to install the Trapwork ................................................... 25

Step 16: Modifications for proper Trap-work fit ............................................ 26

Step 17: Prepare the pedal solenoid for mounting ....................................... 27

Step 18: Mount the sustain lever and pedal solenoid .................................. 28

Step 19: Prepare the sustain lever for operation ......................................... 30

Step 20: Sostenuto lever installation push type ........................................... 31

Step 21 Sostenuto lever installation pull type ............................................ 36

Steinway Sostenuto ..................................................................................................... 40

Step 22: Locating the access hole in the rail cover and mounting the CPU 44

Step 23: Prepare the rail cover .................................................................... 45

Step 24: Prepare the solenoids for installation ............................................ 46

Related product manuals