EasyManua.ls Logo

Piazzetta MP 973 - Stove Status and Shutdown; Low Pellet Notification; Stove Shutdown Procedure

Piazzetta MP 973
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SHUT DOWN
Action Description Display message
Press and briey hold
down the ON/OFF key
SHUT
DOWN
1 2:0022
.
c
1
OFF
1 2:0022
.
c
1
WAIT
COOLING
12:0022
.
c
1
EMPTY
BRAZIER
1
Pellet loading is interrupted, while the room air fan and smoke exit continue
to run, until the stove has cooled.
The appliance shuts off.
SHUT
DOWN
1 2:0022
.
c
1
OFF
1 2:0022
.
c
1
WAIT
COOLING
12:0022
.
c
1
EMPTY
BRAZIER
1
SHUT
DOWN
1 2:0022
.
c
1
OFF
1 2:0022
.
c
1
WAIT
COOLING
12:0022
.
c
1
EMPTY
BRAZIER
1
See the “EMPTY BRAZIER table if the stove shuts down during START
PHASE I or START PHASE II.
SHUT
DOWN
1 2:0022
.
c
1
OFF
1 2:0022
.
c
1
WAIT
COOLING
12:0022
.
c
1
EMPTY
BRAZIER
1
SHUT
DOWN
1 2:0022
.
c
1
OFF
1 2:0022
.
c
1
WAIT
COOLING
12:0022
.
c
1
EMPTY
BRAZIER
1
Action Description Display message
The unit is equipped with a device which informs of the lack of fuel in the
hopper. Where the amount of fuel reaches the minimum level, the unit
works at minimum power and the message SHORT ON PELLET appears
on the display in addition to the time in minutes until the unit goes at,
replacing the usual display (set power level, time and temperature).
An audible beep is also heard, 3 “beeps” sound every 15 minutes.
After a set time has passed, a “beep” lasting 3 seconds is heard, indicating
that the stove will turn itself off after 5 minutes.
Once there are no more pellets left, the display presents the message
PELLET DEPLETED”.
It is no longer possible to start up the stove without rstly replacing the
pellets.
SHORT ON
PELLET
1
26
a It is normal during ordinary operation of the stove at maximum power, where the temperature exceeds a pre-established threshold,
that for a few minutes, the noise of the ventilation motor can be heard, owing to the fact that it increases its speed to the maximum
to allow for the heat to be dispersed and t prevent overheating.
In the STOVE STATUS function the readout "MAX VENT" signals this condition.
DT2040108-01
H072047UK0 / DT2001513 – 04
30
English

Table of Contents

Related product manuals