www.pinell.no Page47
Use of rechargeable batteries
When using rechargeable batteries, its important to set the internal switch in the battery
compartment to Charge On and the switch on the back of the radio to Battery on. This switch is
used to cut the battery circuit from the radio to save battery, when used in battey mod.
Fault-finding
If you have problems with your Internet radio, you may find it useful to refer to the Help section of our web
site: www.pinell.no
.
You will also find useful tips and advice at www.wifiRadio-frontier.com
.
If you experience difficulty in connecting the radio to a wireless network, the following steps may help to
find a solution:
1. Check that a PC with wireless access has access to the Internet via the same network.
2. Check that a DHCP server is available, or that you have configured a static IP address for the radio. To
configure a static IP address for the radio, go to “System settings > Network > Manual settings >
Wireless”, and select “DHCP disable”.
3. Check that the access point does not restrict connections to the MAC address in question. You may
view the radio’s MAC address via “System settings > Network > View settings > MAC address”.
4. If you are using an encrypted network, check that you have provided the correct code or password for
the radio. Remember that codes in alphabetic format are case sensitive. If the radio shows “Wireless
error” followed by a five-digit number when you try to connect to an encrypted network, check that you
have used the correct password for the network. If the problem persists, you may need to check the
network configuration.
5. If the radio is able to connect to the network but cannot play certain stations, the explanation may be:
a. The station is not broadcasting at the moment (remember that it may be in a different time zone).
b. The limit for the number of people who can listen to the station simultaneously has been reached.
c. The station is no longer broadcasting.
To Next Page
Loading...
