Pioneer DVR-310 - Page 49

Recording
06
49
En
• Use the number buttons to enter the PlusCode
programming number. (To clear the last digit
entered, press
CLEAR .)
• Press
REC MODE to change the recording quality
(see also
Setting the picture quality/recording time on
page 44). If Manual Recording is on, then you can
also select the
MN setting.
• Use the
/ (cursor left/right) buttons to select the
Once , Daily or Weekly recording option.
2 After making the settings, press ENTER.
The program details are shown at the bottom of the
screen for a few seconds then the screen is automatically
exited.
• If you haven’t set up the guide channels (or at least
the guide channel for the number that you entered),
the recorder will prompt you to enter the channel
number that the TV program is showing on.
Tip
• You can check the timer program settings by
pressing
TIMER REC to display the timer recording
screen.
VCR Plus+ programming with the power off
You can enter a PlusCode programming number when
the recorder is in standby.
Important
• You can’t use this feature until you have set up the
guide channels. See
VCR Plus+ CH Setting on
page 77
• You can’t change the recording mode.
• You can’t program daily or weekly timer recordings.
1 Press ’VCR Plus+’.
The front panel display shows the current recording
mode and prompts you to enter the PlusCode
programming number.
2 Use the number buttons to enter the number.
• To clear the last digit entered, press CLEAR .
3 Press ENTER.
The display shows the timer settings:
Date
 Start time  End time  Recording channel.
• If
CODE ERROR appears in the display, check that
the number is correct and start again from step
1 .
• If
CAN’T SET appears in the display, it means that
although you entered a valid number, the program
has already finished.
Stopping or extending a timer recording in
progress
After a timer recording has started, you can cancel or
extend recording.
1 Press and hold  REC for 3 seconds.
Only the program is canceled (the timer indicator
disappears); recording continues.
2 If you want to stop recording completely, press
 STOP REC.
• To extend recording, press  REC repeatedly to
extend recording in 30 minute increments.
Preventing use of the recorder before a
timer recording (child lock)
You can make all the front panel and remote control
buttons inoperative using the child lock feature. This is
useful when you set a timer recording and want to make
sure that the timer settings are not changed before
recording has finished.
ENTER
CLEAR
VCR Plus+
PLUSCODE
29324
REC STOP REC

DVR-03_RD.book 49 ページ ２００３年９月１８日 木曜日 午後９時２分