1. Select the Settings button in the Mailing tile on the Home screen.
2. Select Hardware from the list on the left side of the screen.
3. Select Attached scale.
4. Select Adjust for motion to enable the vibration filter. Select Normal to disable the vibration
filter.
5. Select the Home button to return to the Home screen.
Zeroing the scale
You may need to zero the scale if the scale will not display zero weight.
Note:
Always make sure there is nothing on the scale when the system is powered up. At power up, the
system will automatically zero the scale.
1. Select the Settings button in the Mailing tile on the Home screen.
2. Select Hardware from the list on the left side of the screen.
3. Select Attached scale.
4. Select Zero scale.
5. Select the Home button to return to the Home screen.
Resetting the localization value
When you replace your attached scale, you are required to reset the localization value for the scale.
Refer to the installation instructions supplied with the scale for instructions on resetting the localization
value.
System Setup
Pitney Bowes Operator Guide February,2018 Page 240 of 349
To Next Page
Loading...
