Setting the waiting for envelope timeout
Use this option to specify how much time to allow before the feeder stops after the last envelope is
processed. You can set system to run until Stop is selected on the Run Mail screen, or you can set the
system to stop running after a set amount of time, from 5 to 30 seconds.
This reduces the wear on your machine and acts as a safety measure if you leave the machine
unattended.
1. Select the Settings button in the Mailing tile on the Home screen.
2. Select Hardware from the list on the left side of the screen.
3. Select Feeder.
4. Select Edit next to the Waiting for envelopes timeout.
5. Select the appropriate length of time.
l Select Stop machine automatically after rollers stop if you want the feeder to stop after
the last envelope is processed.
l Select Wait for envelopes until stop is pressed if you want the feeder to continue running
until you press the Stop button.
l Select Wait for envelopes for: if you want the feeder to continue running for a short amount
of time after the last envelope is processed. Select and drag the control button to adjust the
timeout. Use the + and - buttons for a more precise selection.
6. Select OK to accept any changes you have made.
7. Select the Home button to return to the Home screen.
System Setup
Pitney Bowes Operator Guide February,2018 Page 242 of 349
To Next Page
Loading...
