User Manual of VDR-300NU
Adding a Bridging WAN service
This section describes the steps for adding the Bridging WAN service.
Step1 First, add a proper ATM or PTM interface for this WAN service at Layer2 Interface.
Step2 On the WAN Service page, click the Add button to display as Figure 5-2-11. You can select
ATM or PTM Interface for the WAN service and then click Next.
Step3 On this page, select the WAN service type to be Bridging. Click Next to finish the setting.
Figure 5-2-21
Step4 On this page, it displays the information about the bridge settings. Click Apply/Save to save and
apply the settings. You can modify the settings by clicking the Back button if necessary.
Figure 5-2-22
47
To Next Page
