18 SHIPPING
48 Planmeca ProScanner User’s & installation manual
18 SHIPPING
The Planmeca ProScanner is a solidly built
system designed to survive shipping around the
world. However, in order to avoid damage
during shipping, the Planmeca ProScanner and
all its accessories must be properly packaged.
In general, the best way to package the
Planmeca ProScanner is in the original factory
container. If this is no longer available, we
recommend carefully wrapping the Planmeca
ProScanner in at least 75 mm (3 inch) and the
Planmeca ProID RFID Reader in at least 25 mm
(1 inch) of foam or bubble pack sheeting. The
wrapped device should then be placed in a
sturdy cardboard carton. Mark the outside of the
box with word FRAGILE and an arrow showing
which way is up.
We do not recommend using loose foam pellets
to protect the Planmeca ProScanner. If the
carton is dropped by the shipper, there is a good
chance that the device will shift within the loose
pellet packing and be damaged.
It is user’s responsibility to package the system
properly before shipping. If the packaging is
inadequate, and the system is damaged during
shipping, the shipper will not honour the user’s
claim for compensation. If the user does not
have a means to adequately package it,
additional shipping containers may be
purchased from Planmeca.
For transportation conditions see section 20
“TECHNICAL SPECIFICATIONS” on page 50.
To Next Page
Loading...
Need help?
General
