1 INTRODUCTION
User’s & installation manual Planmeca ProScanner 1
1 INTRODUCTION
The Planmeca ProScanner is a dental
computed radiography system intended for
capturing, digitization and processing of intra
oral X-ray images stored in imaging plate
recording media. The system scans an x-ray
exposed imaging plate and produces a digital
radiography which can be transferred to
workstation for further processing and routing.
The system consists of a scanner, reusable
imaging plates, RFID reader (optional) and
workstation software.
This manual is valid for ProScanner SW revision
1.0.0.211 or later.
This device must be operated in a radiological
environment by qualified personnel only.
Please read this manual carefully before using
the system.
This device complies with DHHS Radiation
Safety Standards in effect as of the date of
manufacture.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the condition that
the device does not cause harmful interference.
This equipment has been tested and found to
comply with the limits for a Class B Digital
Device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instruction, may cause
harmful interference to radio communication.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment causes harmful interference to radio
or television reception, which can be determined
by turning the device off and on, the user is
encouraged to try to correct the interference by
one or several of the following measures:
To Next Page
Loading...
Need help?
General
