14 RETRIEVING STORED IMAGES
40 Planmeca ProScanner User’s & installation manual
14 RETRIEVING STORED IMAGES
The scanner is equipped with an SD card
capable of storing the scanned image to
memory. The images can be retrieved from the
scanner in the image capturing dialogue in
Planmeca Romexis. For more information, see
Planmeca Romexis 2D Imaging User’s manual.
Retrieving the images is not possible in N-to-N
Ethernet mode i.e. when using ProScanner with
Planmeca ProID reader. If the image must be
retrieved when the scanner is connected using
1-to-1 Ethernet or USB mode.
N-to-N Ethernet mode and 1-to-1 Ethernet mode
cannot be used in the same network at the same
time.
Make sure that the retrieved image belongs to
the selected patient.
To retrieve images from Planmeca ProScanner
1. Connect the PlanmecaProScanner with USB or
with 1-to-1 connection to Planmeca Romexis
workstation.
Retrieving images is not possible in N-to-N mode
2. In Planmeca Romexis 2D imaging module
select ProScanner Capture.
To Next Page
Loading...
Need help?
General
