Plockmatic BK5030 - Best Practice for the BK5030 System

7
56
Best practice for the BK5030 system
• If the set is not properly registered (side jogged and back jogged) changing to a smaller
custom size of paper in the BK5030 may improve the situation.
• If staples have problems penetrating thicker sets of heavy media changing staple car-
tridge may improve the situation.
• If the booklets show markings or scratches the use of the “protection sheet” will im-
prove the situation.
• Book Fold module BF5030 may wrinkle the cover at the spine when light weight media
is used for cover sheet. Changing to heavier stock or turning book fold module off usu-
ally xes the problem.
• Staple may be radius shaped (bent) when running with Book Fold module. Moving sta-
ple position so staple is centered on the spine will reduce this phenomenon.
• Covers may show marking along the spine of the booklet from the clamp in the BF5030
module. The more pages in the booklet, the more evident the marking. The use of “pro-
tection sheet” eliminates this marking.
• For jobs with multiple sheets of 200 gsm or heavier the BF5030 module is recommend-
ed for an acceptable output. If BF5030 module is present in the conguration the Book
Fold shall be turned ON or feed problem at output may occur.