19
Control Panel
The Ready screen
When the system power is switched on, the Ready
screen will be shown. Here you will nd information
showing the actual set up. From this screen you can
also access other screens that will help you operate
the complete BK5030 Booklet making system.
The Jobs screen
Pressing the [Jobs] button in the Ready screen
opens the Jobs screen. From here you can load,
customize and save job settings. These procedures
are described in section 4. Jobs.
The Tools screen
Pressing the [Tools] button in the Ready screen
takes you to the tools screen. This screen looks
different depending of how the system is congured.
From here you can change the display language,
set units from millimetres to inches and more. See
section 3. Tools. for how to get around in the Tools
screen.
Changing settings
To change or adjust settings just point at an item in
the Ready screen. For example you can ne adjust
the trimming, turn off the cover feeder, set the Book
Folder to the correct mode or adjust the staple or
fold position during run. Explore all settings more
thoroughly in section 2. Making Booklets.
To Next Page
Loading...
