BRAKES
9.9
3. Fill reservoir with DOT3 Brake Fluid (PN
2870990).
Polaris DOT 3 Brake Fluid
(PN 2870990)
4. Follow bleeding procedure as outlined in this
chapter. Check all connections for leaks and
repair if necessary.
FRONT PAD REMOVAL
1. Elevate and support front of machine.
CAUTION:
Use care when supporting vehicle so that it does
not tip orfall. Severeinjury may occur if machine
tips or falls.
2. Remove the front wheel. Loosen pad adjuster
screw 2-3 turns.
3. Remove caliper mounting bolts.
4. Push caliper piston into caliper bore slowly using
a C-clamp or locking pliers with pads installed.
NOTE: Brake fluid will be forced through
compensatingportinto master cylinder fluidreservoir
when piston is pushed back into caliper . Remove
excess fluid from reservoir as required.
5. Push mounting bracket inward and slip outer
brake pad past edge. Remove inner pad.
To Next Page
Loading...
Need help?
General
