EasyManuals Logo

Polaris A09BG50AA User Manual

Polaris A09BG50AA
256 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
MAINTENANCE
2.24
MAIN AIR FILTER CLEANING
It is advisable to replace the filter when it is dirty.
However , in an emergency it is permissible to clean
the main filter if you observe the following practices.
G Never immerse the filter in water
since dirt can be transferred to the
clean air side of the filter.
G If compressed air is used never
exceedapressureof 40PSI. Always
use a dispersion type nozzle to
prevent filterdamageand cleanfrom
the inside to the outside.
G Replace the air filter every 50 hours,
and possibly more often in very dirty
conditions.
AIR FILTER/PRE-FILTER
SER
VICE
It is recommended that the air filter and pre filter be
replaced annually. When riding in extremely dusty
conditions, replacement is required more often.
Theprefiltershouldbecleanedbeforeeachrideusing
the following procedure:
1. Lift up on the rear of the seat.
2. Pull the seat back and free of the tabs. NOTE:
When reinstalling seat, makesure theslots in the
seat engage the tabs in the fuel tank.
3. Remove clips (A) from air box cover and remove
cover. Inspectthegasket. Itshouldadheretightly
to the cover and seal all the way around.
A
4. Loosen clamp and remove air filter
assembly.
Gasket
Cover
Pre-filter
Main Element
Ill.1
Carb Boot
Cleaning:
5. Slip the pre-filter element of f of main element.
Clean the pre filter with high flash point solvent,
followed by hot soapy water.
6. Rinse and dry thoroughly.
7. Inspect element for tears or damage.
8. Apply foam filter oil or clean engine oil and
squeeze until excess oil is removed.
9. Inspect mainfilterand replaceif necessary. Ifthe
filter has been soaked with fuel or oil it must be
replaced.
Installation:
10. Reinstall pre-filter element over main filter. Be
sure the element covers entire surface of main
filter without folds, creases, or gaps.
11. Reinstall filter on main filter mount. Place filter
clamp over the assembly and tighten.
NOTE: Apply a small amount of general purpose
grease to the sealing edges of the filter before
reinstalling.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris A09BG50AA and is the answer not in the manual?

Polaris A09BG50AA Specifications

General IconGeneral
BrandPolaris
ModelA09BG50AA
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals