5.60
BODY / STEERING / SUSPENSION
6. Turn the compression adjuster knob counter-clockwise
(soft) until it stops, so damping is in the full open position.
7. Secure the shock body in a vise by its lower mount.
8. Fill the shock body and remote reservoir 1/2 full of the
recommended gas shock oil.
9. Using a 3/32" Allen wrench, remove the IFP bleed screw.
10. Apply a thin film of oil to the IFP O-ring and wear band.
Insert the IFP into the reservoir until it is completely
submerged. Allow air to escape as you install the piston.
11. Screw the IFP Tool (PS-45908) onto the floating piston.
12. Slowly cycle the IFP up and down.
• Be sure to bottom out the piston in the reservoir body.
• Allow time for the bubbles to dissipate.
• Repeat the process until all the air has been removed.
=
Recommended Shock Oil:
Racing Gas Shock Oil (PN 2874522) (Quart)
5 Weight for Walker Evans Shocks
PS-45908
www.midwestmanuals.com www.green-manuals.com
To Next Page
Loading...
