2 - 5
Table 2-1. STAR Tester Controls and Indicators (Con't)
Key No. Control and Indicator Description
12 HORN Cable Connection Accepts plug on Horn cable.
13 Strobe Adapters (Two) * Aligns electronic flash of 600/680
camera under test to STAR Tester.
14 PACK SIMULATOR Jack Connection for film pack simulation
voltage. Lets Tester function as a
power supply.
15 POWER Switch AC line voltage On/Off to tester.
Lights when Tester is powered.
16 DC CURRENT Meter Digital readout of energy required to
charge Strobe capacitor.
17 DC VOLTS Meter Digital readout of circuit voltages;
also use with probe in VOLT
PROBE jack.
18 TIMING Meter Digital readout of strobe recycle time
or blade speed.
19 Test Point Connections For connections to oscilloscope.
(Not Shown) Also used for calibrating Tester.
* Not used for testing ProCam.
Caution: When Tester is not in constant use, turn selector switch to
7000 ZLS position. This saves wear on light source and keeps
Tester in neutral state, ready for immediate resumption of testing.
To Next Page
Loading...
Need help?
General
