To Next Page

To Previous Page

2 - 23

4. Put the Top Cover on the ProCam and then retest the ProCam to verify that

the Catch Pawl catches (stops) the Quintic at the correct position.

Note: If it does not stop at the correct position, re-adjust the adjusting screw

of Solenoid 1, 1/2 turn at a time, until the quintic is caught by the Catch

Pawl.

5. When the proper Quintic catch is achieved, replace the Top Cover.

6. If steps 1 through 3 fail to produce the correct Quintic catch, disassemble the

ProCam to the Shutter level. Inspect the Solenoid 1plunger, the Catch Pawl,

and the Quintic elements for dirt, binding parts and damage. Correct any

problems found, re-assemble the Shutter and then retest the ProCam.

Polaroid ProCam Repair Manual

Other manuals for Polaroid ProCam