Polyend Synth - Sequencer & Arp

Two functions that automate pattern
generation are available for each Synth.
The sequencer is a utility that records a
melody of up to 64 notes and allows this to
be played back with a set of parameters
that affect the behavior. Note increments,
length, as well as swing, and humanization
can be controlled. Notes would be
recorded using the pads and also are used
to trigger the playback of notes respective
to the pad note played. Additionally, an
Arpeggiator is available to generate a
sequential pattern of notes from a chord.
The arp behavior can also be controlled.
Pads are also used to play a chord or
selection of notes from which the arp
generates a pattern. The chord A groove
function is available to both the sequencer
and the arp, which consists of 11 style
templates that apply note sequences and
rests to create…. well… a groove. The
sequencer and arp can also be turned off,
and the pads are simply used to generate
notes. The sequencer and ARP settings are
saved and recalled with the scene.
Sequencer & Arp
7
105
Polyend Synth Manual
104
Polyend Synth Manual