113
Polyend Synth Manual
112
Polyend Synth Manual
NOTESNOTES
Sequencer & Arp
7
Sequencer & Arp
7
Arp patterns are saved for each synth with the Scene. The process of
creating an Arpeggio is performed in [Seq] Arp Mode using the pads. Once
created, the Arp parameters can be adjusted.
▌ CREATING AN ARPEGGIO
1. Select the Synth to edit. Press the screen button for the selected Synth.
2. Open the Arp page. Press [Seq] to cycle to the Seq Page 2.
Alternatively in the Sequencer page, Turn the rst parameter knob to
select between Off, Arp, Seq On. Any previous pattern is retained when
switching from Off.
3. An arpeggio is only created when a selection of pad notes are held or
locked. It is good practice to lock pads for a chord using [Shift] + [Pad].
Once a chord is played or locked the Arp can be set.
4. Start by setting the Rate and Gate Length. These will determine the
speed of the notes and the length of each.
5. Select one of the groove templates by turning (Groove). The rests will
be shown as dimmed dots and bright dots are notes. This determines
the sequence played.
6. Adjust (Type) to select the direction of the arpeggio pattern. This sets
the order that the notes will play and loop.
7. Finally the Swing and Humanize settings can be adjusted to add some
natural rhythm and shufe to the pattern.
8. To Save an Arp setting, Save the Scene. Arp settings are saved for the
Synths with the Scene.
To Next Page
Loading...
