A-5
A Optional Accessories
Figure A.2: Assembling the pan-tilt head onto the tripod
11. Screw the connector box on the adapter plate using the four M8 x 40 Allen
screws. To do this, use the size 6mm Allen key.
12. Fix the pan-tilt head on the connector box using the three M8 x 16 Allen
screws and corresponding washers.
13. Assemble the scanning head with mounting plate onto the pan-tilt head
using the two M6x16 Allen screws and the corresponding washers as
shown in the following figure.
Adapterplate
3 M6x20 Allen screws
Connector box
4 M8x40 Allen screws
3 M8x16 Allen screws
Pan-tilt stage
Tripod
Tripod plate
Rotary handle