Precor Experience Series - Page 182

ID Interface
Lift Motor Fuse (6.3A)
LPCA Power Supply Fuse(2A)
Procedure
Review entire procedure before starting.
Removal Instructions
1. Remove the Left Drive Disk Cover, see "Drive Disk Covers Replacement" on page84.
2. Remove the one #2 Phillips screw fastener and remove the LPCA/Battery Module
cover. Retain part(s) and/or fastener(s) for installation.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 174
6 Replacement Procedures
LPCA (Lower PCA) Board Replacement