Precor Experience Series User Manual

11. .Verify the crossramp incline operation through the full range of motion from the min-
imum to maximum ranges. Access the service CROSSRAMP TEST diagnostic test
and raise/lower the incline level several times from the minimum to maximum levels.
l .On LED (P10, P30, P30i and P31) consoles: Access diagnostic test menu
(51765761) and select MACHINE TEST > CROSSRAMP TEST.
l .On touchscreen (P62, P80, and P82) consoles: Access the Service menu
(51765761) and select System Settings > Systems Test > CrossRamp Test.
12. Reinstall the Rear Lift cover (see "Lift Rear Cover Replacement " on page77), the
Accessory Tray cover (see "Accessory Tray Cover Replacement" on page77), the Lift
Interface Plate cover (see "Lift Interface Plate Cover Replacement" on page76), the Lift
Front cover, the Goose Neck cover and gasket (see "Lift Front Cover Replacement" on
page72).
13. Verify elliptical operation and return to service, see "Operation Verification" on page16.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 64
5 Adjustment/Calibration Procedures
Lift Motor Calibration

Precor Experience Series Specifications

General

Brand	Precor
Model	Experience Series
Category	Fitness Equipment
Language	English