Operating modes
n
[auto]
: The controller analyses the
temperature signal from the tempera‐
ture sensor connected
– For measurements using a tem‐
perature sensor (0 ... 150 °C)
n
[manual]
: The temperature of the
medium to be measured has to be
measured by the user. The deter‐
mined value is then entered using the
keys:
and in the
[VALUE]
parameter into the controller and is
saved using .
– This setting is needed for meas‐
urements where the medium to
be measured has a constant tem‐
perature. The temperature is
taken into consideration in the
control.
Control parameters and functions
83
To Next Page
Loading...
