Error messages
Error mes‐
sage
[Error ]
[Warning]
Brief description of fault
[RANGE↓]
E The main measured variable falls below the measuring range
[RANGE↑]
E The main measured variable exceeds the measuring range
[T
RANGE↓]
E Temperature value falls below the measuring range
[T
RANGE↑]
E Temperature value exceeds the measuring range
[CAL
ERROR]
E Calibration error during last calibration performed by the user
[CHECK‐
TIME]
E
See chapter
Ä Chapter 10.7 ‘Checkout time control’
on page 84
[mA
RANGE↑]
E The current emitted at the mA standard signal outputs is
higher than 20 mA. This does not apply with the issue of the
23 mA error current
[mA
RANGE↓]
E The current emitted at the mA standard signal outputs is
below 0/4 mA. This does not apply with the issue of the 0/3.6
mA error current
[LIMIT↑]
W Main measured variable is higher than the limit set
[LIMIT↓]
W Main measured variable is lower than the limit set
[T LIMIT↑]
W Correction measured variable higher than the limit set
[T LIMIT↓]
W Correction measured variable higher than the limit set
[LIMIT
ERR]
E
See chapter
Ä Chapter 10.6 ‘Checkout time for measured
variable and correction variable’ on page 84
[TLIMI‐
TERR]
E
See chapter
Ä Chapter 10.6 ‘Checkout time for measured
variable and correction variable’ on page 84
[NO CAL]
W No calibration has been performed by the user
[CON‐
TACTIN]
E Alarm triggered by contact input (
[INPUT]
menu:
[ALARM=on]
selected)
[TDS↑]
W The TDS value is too high Continuous display: >2000
Maintenance
90
To Next Page
Loading...
