Promise Technology Pegasus32 R6 - Page 155

139
Managing the Pegasus32Pegasus32 Product Manual
Rebuilding a Disk Array
When you rebuild a disk array, you are actually rebuilding the data on one of its physical drives.
Ifthereisnosparedriveofadequatecapacity,youmustreplacethefaileddrivewithanuncongured
physical drive, then perform a Manual Rebuild.
On the carrier with the failed drive, the Drive Power / Status LED is red and the Drive Activity LED is
dark.
That is the physical drive you must replace.
Red LED
Dark LED
Drive carrier LEDs for a dead or failed drive