Promise Technology Pegasus32 R6 - Page 35

19
Installation and SetupPegasus32 Product Manual
Installing the Software on your Mac
ThePegasus32unitshipsreadytousewithoutcongurationorset-up;howeveritisagoodideato
installthePegasusUtilitysoftwareevenifyoudonotplantomakeanychangestodeviceconguration.
Theutilityisusefulformonitoringthesystemandgettingrmwareupdates.
TheutilityisnecessaryifyouplantochangethedefaultRAIDconguration(Pegasus32isshippedwith
a RAID 5) or if you will swap out any of the hard disks shipped with the device.
The software utility installation package is located on the Pegasus32. Follow the instructions below to
install the utility.
To install the Pegasus32 Software Utility:
1. Double-click on the Pegasus32 icon on your desktop to
view the device contents.
2. FindtheleR_PROMISE_Utility_ 40400000x.dmg and double-
click on it to mount the virtual drive containing the installation
software package.
Note that the version number
of the .dmg le and .pkg le
will change as it is updated.
The version number used in
this example is just for the
purpose of illustration.
Note
If you get any warning message during installing driver or software, please refer to
“Troubleshooting” on page 179.