vii
About this guidePegasus32 Product Manual
Safety Information
Observe all warnings on the product and in the operating instructions. To reduce the risk of bodily
injury, electric shock, re, and damage to the equipment, observe all precautions included in this guide.
You must become familiar with the safety information in this guide before you install, operate, or service
PROMISE products.
Use environment
• Make sure that the area in which you install the equipment is properly ventilated and climate controlled.
The operate normally in the temperature of 5 º C – 35 º C and relative humidity of 10% – 95%.
• Ensure that the voltage and frequency of your power source match the voltage and frequency
inscribed on the electrical rating label of the equipment.
• Never use the equipment in a wet location.
Chassis
• Do not block or cover the openings to the equipment.
• Never push objects of any kind through openings in the equipment. Dangerous voltages might be
present.
• Conductive foreign objects can produce a short circuit and cause re, electric shock, or damage to
your equipment.
• Lift equipment using both hands and with your knees bent.
Power Cords
To reduce the risk of electric shock or damage to the equipment:
• Use an approved power cord. If you have questions about the type of power cord to use, contact
your PROMISE TECHNOLOGY INC. authorized service provider.
• If you have not been provided with a power cord for your product or for any AC-powered option
intended for your product, purchase a power cord that is approved for use in your country.
• You must use a power cord rated for your product and for the voltage and current marked on the
electrical ratings label of the product. The voltage and current rating of the cord must be greater
than the voltage and current rating marked on the product.
• Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.
• Do not place objects on AC power cords or cables. Arrange them so that no one might accidentally
step on or trip over them.
•
Do not pull on a cord or cable. When unplugging from the electrical outlet, grasp the cord by the plug.
• To reduce the risk of electrical shock, disconnect all power cords before servicing the equipment.
To Next Page
Loading...
Need help?
General
