Tsunami QB-8100 Series (100 Mbps/5 Mbps Models) Installation and Management Guide 159
6.3.2 Learn Table
Learn Table is used to view all MAC addresses the device has learnt on an interface. The Learn Table displays the information
of learnt MAC addresses, the interface on which it learnt the MAC address, aging timer corresponding to the MAC add entry,
and the type of interface as local interface or attached interface to the device. It reports the MAC address for each node that
the device has learnt on the network and the interface on which the node was detected. There can be up to 10,000 entries in
the Learn Table.
To view the Learn Table entries,
1. Click MONITOR > Bridge > Learn Table.
In Unicast Packets Displays the number of subnetwork unicast packets
received at the bridge interface.
In Non-unicast Packets Displays the number of non-unicast (i.e.,
subnetwork-broadcast or subnetwork-multicast)
packets received at the bridge interface.
In Errors Displays the number of inbound packets that
contained errors and are restricted for delivering them
to a higher-layer protocol at the bridge interface.
Out Octets Displays the total number of octets transmitted out of
the interface, including the framing characters.
Out Unicast Packets Displays the total number of packets requested by
higher-level protocols to be transmitted out of the
interface to a subnetwork-unicast address, including
those that were discarded or not sent.
Out Discards Displays the number of error-free outbound packets
chosen to be discarded to prevent them being
transmitted. One possible reason for discarding such a
packet could be to free up buffer space.
Out Errors Displays the number of outbound packets that could
not be transmitted because of errors.
Parameter Description
To Next Page
Loading...
Need help?
General
