Tsunami QB-8100 Series (100 Mbps / 5 Mbps Models) Installation and Management Guide 16
2
Installation and Initialization
This chapter describes the steps required to install and mount the QuickBridge 8100 Series units. If you are already familiar
with this type of product, refer to the Tsunami QB-8100 Quick Installation Guide for streamlined installation procedures.
This chapter covers the following topics:
• Hardware Overview
• Product Package
• Installation Procedure
– Step 1: Plan for Installation
– Step 2: Choose a Location
– Step 3: Gather Required Tools
– Step 4: Unpack the Product Package
– Step 5: Assemble the Cable
– Step 6: Mount the Unit
– Step 7: Plug in the Cables
– Step 8: Ground the Unit
– Step 9: Power on the Unit
– Step 10: View LEDs
• Initialization
– ScanTool
– Setting the IP Address with ScanTool
• Logging in to the Web Interface
• Factory Default Configuration
To Next Page
Loading...
Need help?
General
