Tsunami QB-8100 Series (100 Mbps/5 Mbps Models) Installation and Management Guide 41
4.1 System Configuration
The System screen allows you to configure the QB-8100 device as an End Point A or an End Point B, the frequency domain,
and the network mode as Bridge or Routing.
To configure the System
1. Click ADVANCED CONFIGURATION > System. The System screen is displayed as shown below:
Figure 4-1 System screen
2. From the Radio Mode drop-down menu, select either End Point A or End Point B.
3. From the Frequency Domain drop-down menu, select a frequency domain.
4. From the Network Mode drop-down menu, select either Bridge or Routing.
5. For the Maximum MTU field, enter the maximum MTU value.
6. Click OK.
The following table lists the System parameters and their descriptions:
Parameter Description
Radio Mode Radio mode specifies the mode of operation and
QB-8100 supports two types of modes, End Point A
and End Point B.
Frequency Domain A valid frequency domain must be set before the
device can be configured with any other parameters.
Selecting a frequency domain makes the device
compliant with the allowed frequency bands and
channels for that regulatory domain.
Network Mode The device can be configured in two network modes:
Bridge Mode and Routing Mode. The default network
mode is Bridge Mode.
Refer to Configuring IP in Bridge or Router Mode for
more information.
Active Network Mode This is a read-only parameter which shows current
operating network mode of the device. It is displayed
only when the newly configured Network mode differs
from the current Active Network mode.
To Next Page
Loading...
Need help?
General
