Prusa i3 MK2S KIT - Y a Xis a Lignment ( Kit O Nly)

5) XYZ   calibration   all   right.   A   skew   will   be   corrected   automatically.
You may consider to re-align the X/Y axes (as described in the chapter 6.3.5.1 Y
axis alignment). Still the firmware will correct the skew during normal printing and as
long as the X and Y axes move freely, the printer will print correctly.
6) XYZ   calibration   failed.   Left   front   calibration   point   not   reachable.
Even if the printer moves the print bed to the end Y end stop, the PINDA probe
cannot reach the left front bed calibration point. Move the left Y threaded rod in the Z
frame away from you, so the PINDA probe reaches the left front bed calibration point
reliably. You can find how to fix this in the next chapter 6.3.5.1 Y axis
alignment.
7) XYZ   calibration   failed.   Right   front   calibration   point   not   reachable.
Even if the printer moves the print bed to the end Y end stop, the PINDA probe
cannot reach the right front bed calibration point. Move the right Y threaded rod in the
Z frame away from you, so the PINDA probe reaches the right front bed calibration
point reliably. You can find out how to fix this in the next chapter 6.3.5.1 Y axis
alignment.
8) XYZ   calibration   failed.   Front   calibration   points   not   reachable.
Even if the printer moves the table to the end Y end stop, the PINDA probe cannot
reach the front row of the bed calibration points. Move both left / right Y threaded
rods in the Z frame away from you. You can find out how to fix this in the next
chapter 6.3.5.1 Y axis alignment.
9) XYZ   calibration   compromised.   Left   front   calibration   point   not   reachable.
XYZ   calibration   compromised.   Right   front   calibration   point   not   reachable.
XYZ   calibration   compromised.   Front   calibration   points   not   reachable.
Printer will likely work, but the bed leveling may be compromised and the skew of the
X/Y axes may not be fully corrected. It is recommended to adjust the positions of the
Y threaded rods in the Z frame as in cases 6) to 8). You can find out how to fix this
in the next chapter 6.3.5.1 Y axis alignment.
During the mesh bed leveling procedure following errors may be reported on the display.
1) Bed   leveling   failed.   Sensor   disconnected   or   cable   broken.   Waiting   for   reset.
Verify, whether the PINDA probe cable is plugged into the RAMBo board correctly. If
it is the case, the PINDA probe is broken and it needs to be replaced.
2) Bed   leveling   failed.   Sensor   didn’t   trigger.   Debris   on   nozzle?   Waiting   for   reset.
17