Prusa i3 MK2S KIT - P Rinter S Tops P Rinting S Oon a Fter S Tart; P Rinter C Ant R Ead S D C Ard

13.2 Printer stops printing soon after start
Extruder is likely overheated. Make sure the nozzle fan is working properly. If not, please
inspect its connection according to the assembly manual.
Pict.   32   -   Proper   wiring   of   the   connectors
13.3 Printer can’t read SD card
First, make sure that the file name on the SD does not contain special characters -
otherwise the file could not be displayed on LCD. If there is no error in the file name, check
the EXT2 wiring (from electronics to LCD). If the cable is connected properly, try to swap the
cables.

 
55