Prusa i3 MK2S KIT - Page 36

It may look that the compensations are not that high at the first sight. However, if we take
into consideration the 250 mm X-axis length, 1.1 mm is a large margin. In order to improve
your axis perpendicularity, make sure the the distance of the front calibration points (seen on
the first screen) is the same.
Pict.   19   -   Moving   one   side   of   the   frame   forward   (increasing   the   measured   value)   on   the   Y
axis   and   other   side   backward   (decreasing   the   measured   value)   according   to   the   values   from
the   first   screen   will   improve   the   skew.

 
36