The “Region” setting influences the decimal symbol, date display format,
and default volumetric units. This only affects user interface and has no
impact on sensor operation.
The “Factory Reset” function will default user and service parameters on the
controller. Enter 4 to confirm reset. This does not affect Flow Pulse
parameters.
Data Logging
Data logging saves the flow information with timestamps onto a file. This
function is only available when a sensor is connected.
The default logging interval is one log per 4 seconds. This can be changed
from 2 to 3600 seconds interval between logs in Settings-2 Data Logger
Logging Interval menu.
A new log file is always generated when logging is started or restarted.
During logging, a new file is also generated upon a new day as determined
by the File Interval setting (1 day by default).
A short data logging session can be activated by using the “F2” key. A
prompt will appear to confirm or change the site name. Use the “Cancel”
key to delete existing characters, and alphabets can be selected by repeated
pressing on a numeric key to switch to the relevant alphabets as shown by
the alphanumeric diagram. Use Enter to confirm the site name.
To Next Page
Loading...
