Page 35
System Information
Press F4 to Settings2-Controller menu and select “Device Info”. This will
display the serial number, firmware and hardware versions, on-board
temperature, and internal storage information for the controller.
Internal Storage
The internal storage comprises of a 4 GB flash memory, with approximately
3.8 GB available.
It is therefore recommended that files on the internal storage are transferred
onto a computer via USB when possible, and deleted from the internal
storage. The internal storage should not be used as the main storage
location for critical log or parameter files.
Upgrading Firmware on the Flow Pulse Handheld
Before starting this procedure, the following are required:
• A PC with FlowPulse PC installed, which can be found on the
FlowPulse PC CD or downloaded from:
http://pulsar-pm.com/support/downloads/software.aspx )
• The firmware file you wish to install on to the Flow Pulse
Handheld
• A USB to serial converter with RJ11 lead (Pulsar programming lead)
• A Philips screwdriver for removing the screws on the back of the Flow
Pulse Handheld
Follow these procedures carefully to upgrade the firmware on the handheld
controller:
1) Ensure the Flow Pulse Handheld has more than 50% battery
charge or that the power cable is plugged in and the Flow Pulse
Handheld is charging
2) Power-down Flow Pulse Handheld, disconnect Flow Pulse and
charger or any external power source
To Next Page
Loading...
