Pulsar FLOW PULSE - Accessing the Totaliser Options; Totaliser Multiplier

Page 32
Accessing the totaliser options
Pressing the F4 key will take you to the “Settings 2-Controller” menu
options where you will need to select “6-Totaliser”. You are now given the
opportunity to choose different totaliser options.
Totaliser Multiplier
This can be used if the totaliser increments by too large or too small amount,
enter the factor by which the actual flow rate is multiplied by before
incrementing the totaliser.
E.g. if flow rate is being calculated and displayed in litres /second and it is
desired to increment the totaliser in cubic metres select 13 = *1000. When
viewing the totaliser display will state; “x 1000 ltr”, and the totaliser will be
incremented every 1000 litres.
Options are:
Totaliser Option
Description
1 / 1000000
Totaliser will increment every 1 / 100,000,000 units of flow
1 / 100000
Totaliser will increment every 1 / 100,000
th
units of flow
1 / 10000
Totaliser will increment every 1 / 10,000
th
units of flow
1 / 1000
Totaliser will increment every 1 / 1,000
th
units of flow
1 / 100
Totaliser will increment every 1 / 100
th
units of flow
1 / 10
Totaliser will increment every 1 / 10
th
units of flow
*1
Totaliser will increment every 1 unit of flow
*10
Totaliser will increment every 10 units of flow
*100
Totaliser will increment every 100 units of flow
*1000
Totaliser will increment every 1,000 units of flow
*10000
Totaliser will increment every 10,000units of flow
*100000
Totaliser will increment every 100,000 units of flow
*1000000
Totaliser will increment every 1,000,000 units of flow