51
It takes about 60sec for the lights to
turn on after setup
Conn d o Sol- and has po
Conne o In n
and S
Conn o
rou
bu not (usually a V
or f
all issu
The app will buffer for
a few seconds.
confirmation once
connection is established.
3. Connect the System to the Internet
Read and
confirm
conditions.
Select Distribution
with WIFI
If Wi-Fi paired
with 10.10.10.1,
select Done
If Location Services
are not enabled, it will
be requested.
Once you see this screen, go to
your DEVICE’s
Wi-Fi settings
and connect to the
Wi-Fi network that starts with:
EAP-#####
Password: “12345678”
Return to app once connected
Select the local Wi-Fi network that will be
providing the internet connection to the
system.
Do NOT select the dongle’s Wi-Fi
network.
To Next Page
Loading...
