Q-See QT426 User Manual

GETTING STARTED QT426 User Manual
11 | Page
2.4 Remote Control
The remote control uses two AAA size batteries. Instructions for operation are as follows:
Step 1: Open the cover of the Remote Control
Step 2: Place batteries making sure the poles are correct (+ and -)
Step 3: Replace the battery cover
If the remote does not work check the following:
1. Check the pole position of the batteries
2. Check the remaining charge in the batteries
3. Check to make sure the sensor on the DVR is clear
4. If it still doesn't work, contact Q-See for a replacement
Figure 2-5 below illustrates the Remote Control functions as follows:
Fig 2.5 Remote Control
ITEM
NUMBER
PHYSICAL CONNECTOR CONNECTOR DESCRIPTION
1 POWER BUTTON
Soft switch off to stop firmware running. Use this prior to turning off the
DVR.
2 INFO BUTTON
Get information about the DVR like firmware version, HDD information
3 REC BUTTON
To record manually
4 NUMBER BUTTONS
Input numbers or choose camera
5 MULTI SCREEN BUTTON
To choose multi screen display mode
6 SEARCH BUTTON
To enter search mode
7 MENU BUTTON
To enter menu
8 ENTER BUTTON
To confirm the choice or setup
9 DIRECTION BUTTON
Move cursor in setup or move PTZ camera

Q-See QT426 Specifications

General

Brand	Q-See
Model	QT426
Category	DVR
Language	English